HAULTENT Expeditions Trailers Have: |
All welded, 5052, H32, 1/8 aluminum skin
Stainless steel bolts, hinges and hardware
Light weight. 1000 lbs empty
GVWR: 3000 lbs
-
Full size bearings, hubs, brakes and 15" wheels
-
Dust resistant.
|
 |
3500lb Rubber Torsion axle with Safe-t-lube bearings. With Rubber Torsion axles, there are no suspension parts to wear out (spring shackles, hangers, etc.) Rubber cushioning eliminates metal-to-metal contact. The independent suspension allows each wheel to travel totally independent from the others. A smoother ride, less sway and reduced noise is achieved with the rubber suspension. Aluminum, 4" channel frame
|
 |

Large 6ft x 18in counter
Portable, aluminum table that attaches to any of the three drawers.
3 large, 18"x16"x4", all aluminum, roller bearing drawers that won't bounce apart on the roughest roads. 2, 4"x 40"x78" comfortable beds and seating.
|  |

One sturdy, aluminum, hinged tent pole, (so there aren't allot of parts to lose) that supports the entire tent. It folds and latches into the inside of the trailer.
12 volt electrical system with 2 power point outlets.
|
|
Locking door secures the entire trailer. The step is built into the door that may be opened without opening the entire trailer. Incredible 100+ cu. ft. of storage space such as in the step, under the counter, under the beds. No wasted space!
|
|
HAULTENT Expedition trailers DO NOT have
Lots of moving parts that can break on a rough road Plywood, particle board, press board, fiberglass, staples, nails, screws, glue, paper thin siding or trim (used for covering mistakes and poor fit!) Any bells, whistles or fluff Anything Hanging under the floor to get ripped off on the first rock or gully (yes, it happens) Any little bitty tire, wheels or bearings to burn up.
|